DJ-6000 ROLLING BRIDGE JACK
Dannmar’s DJ-6000 rolling bridge jack is built strong and sturdy with a 6,000 lb. lifting capacity. This bridge jack is specifically designed for use with a Dannmar’s four-post lift with standard runways and 12,000-lb. lifting capacity. The DJ-6000 provides you with the versatility and added access to raise the wheels off the runways of the vehicle lift.
Dannmar’s DJ-6000 Rolling Bridge Jack is the simple and safe way to turn your lift into a full-service car lift. With this Rolling Bridge Jack’s 6,000-lb. lifting capacity, you can take on even more types of vehicle repairs. Simply position the jack under the appropriate front or rear chassis area, and lift the vehicle up and off of the runways. Each chassis-engaging jack raises one-half of the vehicle, and two will raise all four wheels above the runways. Each four-post rolling bridge jack can be raised to three different heights. Locks engage automatically as the jack scissor arms raise, and they release simultaneously as the arms are lowered. Welded to the side of the rolling bridge jack, is a high-pressure, air-hydraulic pump that requires 125 psi and 10-20 CFM. It’s activated when you press a foot pedal attached to the unit.
- 6,000-lb. lifting capacity
- Rubber contact pads
- Stackable adapters to maximize arm reach
- High-pressure commercial air-hydraulic power unit; foot operated
- Optional air-line kit
Lifting Capacity 6,000 lbs. (2,722 kg)
Max. Height + Pad Only 16.5” (419 mm)
Max. Height + Pad + Adapter 20” (508 mm)
Min. Height + Pad Only 6.5” (165 mm)
Min. Height + Pad + Adapter10” (254 mm)
Support Arm Width 35” (889 mm) - 45.5” (1,156 mm)
Max. Arm Reach 56” (1,422 mm)
Min. Arm Reach 42” (1,067 mm)
Motor Air-Hydraulic Pump
Noise 45 dB
Lifting Time 45 seconds
The telescoping roller design allows the runways to be adjusted for different tread widths, so you don’t need adapters to work on different vehicles. The ability for the DRJ-6 to reach anywhere beneath the vehicle is attributed to its steel rollers that allow you to easily manipulate where the bridge jack is placed beneath the vehicle.
Dannmar rolling jacks are designed to be easily installed and easily removed. Just move your DRJ-6 out of the way when you need the space.
Each jack comes complete with three safety-lock positions and stackable pad adapters to provide added clearance when needed. Included commercial-grade air-hydraulic pump requires 125 psi and 10 – 20 CFM.
Minimum Support Arm Width 35”
Maximum Support Arm Width: 45.5"
Minimum Height (Pad with Adapter): 10"
Minimum Height (Pad only): 6.5"
Maximum Height (Pad with Adapter): 20"